Download Bosch Solution 16plus Specifications

Transcript
!"#$%&"'()* Operators Manual
9
FAULT Indicator
The FAULT indicator is used to display that the system has detected a system fault. Refer to
Fault Analysis Mode on page 16 for additional information on system faults.
Every time a new system fault has been detected (eg. FAULT indicator flashing), the
codepad will begin to beep once every minute. Pressing the # button once will cancel the
once a minute beep and acknowledge the fault (eg. FAULT indicator on steady).
FAULT Indicator
Definition
On
There Is A System Fault That Needs To Be Rectified
Off
The System Is Normal, There Are No Faults
Flashing
There Is A System Fault That Needs To Be Acknowledged
Table 5: FAULT Indicator
Audible Indications
In general, the audible indicators given out by the codepad buzzer are as follows:
Audible Indicator
Definition
Once Short Beep
A Button Has Been Pressed On The Codepad, Or, End Of Exit
Time When Armed In STAY Mode 1 Or STAY Mode 2
Two Short Beeps
Three Short Beeps
One Long Beep
One Beep Every Second
One Short Beep Every
Minute
The System Has Accepted Your Code
The Requested Function Has Been Executed
Indicates the End Of Exit Time When Armed In AWAY
Mode, Or The Requested Operation Has Been Denied Or
Aborted
Walk Test Mode Is Currently Active Or Warning Before
Automatic Arming Takes Place
There Is A System Fault Waiting To Be Acknowledged
Table 6: Audible Indicators
Electronics Design and Manufacturing Pty Limited
ISSUE160.DOC