Download Sharp R-65STR Specifications
Transcript
Loveland Fire/Rescue Pumper Production Specification TWO STAGE TRANSFER VALVE The transfer valve shall be of the latest ball type design. The valve shall be all bronze construction and incorporate a hydraulically balanced seal to minimize leakage around the ball and assure maximum pump efficiency. The transfer valve shall operate smoothly without sticking, even when it is exposed to sandy or dirty water. The transfer valve shall be operated by an electric actuator that will be controlled by a switch on the pump operator's panel. There shall be two (2) indicator lights to show when the pump is operating in pressure or volume mode. UNDERWRITERS LABORATORIES FIRE PUMP TEST The pump shall undergo an Underwriters Laboratories Incorporated test per applicable sections of NFPA standards, prior to delivery of the completed apparatus. The UL acceptance certificate shall be furnished with the apparatus on delivery. FIRE PUMP TEST LABEL A fire pump performance and rating label shall be installed on the fire apparatus pump panel. The label shall denote levels of pump performance and testing completed at factory. These shall include GPM at net pump pressure, RPM at such level, and other pertinent data as required by applicable NFPA standards. In addition, the pressure control device, tank to pump flow tests, and other required testing shall be completed. In addition, the entire pump, suction and discharge passages shall be hydrostatically tested to a pressure as required by applicable NFPA standards. The pump shall be fully tested at the pump manufacturer's factory to the performance specifications as outlined by applicable NFPA standards. UL PUMP CERTIFICATION The fire pump shall be tested and certified by Underwriters Laboratories, to perform as listed below: 100% of rated capacity at 150 psi, 1000 kPa net pressure. 70% of rated capacity at 200 psi, 1350 kPa net pressure. 50% of rated capacity at 250 psi, 1700 kPa net pressure. The entire pump, both suction and discharge passages, shall be hydrostatically tested to a pressure of 500 PSI. The pump shall be free from objectionable pulsation under all normal operating conditions. ALTITUDE REQUIREMENT The apparatus shall be designed to meet the specified rating at 7,000 feet altitude. WATEROUS PUMP ANODES There shall be two (2) Anodes provided with the Fire Pump. One (1) anode shall be installed in the left steamer and one (1) shall be installed in the right. SVI #769 Page 101 of 125 ..\4) Pricing & Change Orders\Production Change Order.pdf June 17, 2010