Download Bosch WTS86500GB Technical data

Transcript
Emptying condensation
Drying
Empty the container after each drying cycle, not during drying!
1. Remove the container, holding it level.
2. Pour out condensation.
3. Push the . container back in until it clicks into place.
Inspecting
the dryer
nnecting the
mains plug
Cleaning the fluff filter
1.
2.
3.
4.
Condensation container
oading laundry
Drum
Control panel
Clean the filter in the water tank if it is dirty
1.
2.
3.
4.
age 8.
woollens”
he programme
drying programme ...
idual requirements
1
2
are sensitive,
h is enough!
Open the door, remove the filter and fold open.
Remove the fluff (by wiping the filter with your hand).
Close the filter, insert it again and close the door.
Remove fluff from the door and the area around it.
Very dirty or blocked filters should be rinsed under warm
water, and then dried thoroughly.
Remove the condensation tank.
Remove the filter.
Clean the filter under running water.
Re-insert the filter and push in the condensation tank until it clicks into
place.
Water tank
filling hole
with filter
Switching off the dryer
Cover for
steam nozzle
Removing the laundry
Turn the programme selector to Off.
Do not leave damp laundry in the dryer.
The automatic Easy Iron function moves the drum at certain intervals. The load remains loose and soft for
an hour (or two hours if you manually select the cReduced Ironing function, depending on the model.)
Start/Stop button
3
Air cooler
Fluff filter
a 2h;
loud).
Air inlet
Programme end once \ lights up in the display.
Interrupt programme removing or adding laundry.
1 -24 hrs
0, 1, 2, 3, 4
On-Off
for the
0, 1, 2, 3
esetting = 0.
he others.
600-1800
²
The drying cycle can be interrupted for a brief period so that laundry may be added or removed.
The selected programme must then be continued until it is finished.
Drying / Short spin /
Refresh
Hot steam may escape during the Steam Drying / Steam Refresh programmes.
1.
2.
3.
4.
3
Open the door. The drying cycle is paused.
Remove or add laundry and close the door.
If required, select a new programme and additional functions.
Press the Start/Stop button. The remaining time is updated after a few minutes.
4