Download Marshall Amplification 2203 Technical information
Transcript
Step 17: Wiring the OT primary wires, installing output jacks. Twist the RED and BROWN wires from the OT and route to V5 and V6. Make sure to complete a minimum of five complete twists, as shown. >> Attach the RED wire to the lower hole in the terminal at PIN 3 of V5. Solder in place. Route the BROWN wire to PIN 3 of V6 and attach likewise. Locate (4”) of each RED and BROWN 22g wire. Install these as jumpers between octal sockets as shown. RED jumpers V4, PIN 3 to V5, PIN 3. And BROWN jumpers V6, PIN 3 to V7, PIN 3. You can zoom in for clarity and/or reference the full amp wiring diagram in the APPENDIX. TECH NOTE: Output tube socket pin 3’s are connected together in pairs to allow one pair of output tubes to drive each side of the OT primary. V4 and V5 drive one side while V6 and V7 drive the other. This is crucial to the PUSH-PULL arrangement of a100 watt Marshall output section. It also illustrates why you pull either the two outside tubes or two inside tubes together, as a pair, to reduce amp output. Locate a 4” piece of 22g BLACK wire and attach to the ground lug on the V5 mounting bolt. Ensure a solid solder connection as this is a critical connection. Route the wire as shown. Locate (2) CLIFF JACKS. Install in the chassis holes using the hardware sequence: JACK – FIBER WASHER – CHASSIS – PLASTIC NUT Tighten the plastic nut with pliers or a 15mm socket or wrench. Do not over-tighten. Cut the BLACK ground wire to length, strip ½” of insulation and attach to the terminal on the LEFT jack as shown. Solder in place, but leave room in the top of the terminal for the buss wire which will later connect each of the four terminals nearest the rear of the chassis.