Download OKIPAGE 14ex Led Printer
Transcript
2.1 Main Control Board The main control board consists of a single chip CPU, two program/font ROMs, four DRAMs, an EEPROM, a host interface circuit, and a mechanism driving circuit. (1) Single chip CPU The single chip CPU is a custom CPU (32-bit internal bus, 32-bit external bus, 49.766-MHz clock) which incorporates the RISC CPU and its peripheral devices, and has the following functions: (2) Program and Font ROMs Built-in device Chip select controller Function Control of ROM, DRAM and I/O device Bus controller DRAM controller DMA controller Transfer of image data from DRAM to video output port Parallel interface controller Control of Centronics parallel interface Serial interface controller Control of RS-232C serial interface Video output port Control of LED head LED STB output port Timer Generation of various control timing Monitoring of paper running and paper size Serial I/O port Control of operator panel, EEPROM, and options I/O port Input and output of sensor and motor signals The Program and Font ROMs store the equipment program and various types of fonts. Mask ROM is used as Program and Font ROMs. The mounting locations of these Program and Font ROMs vary depending on the type of the ROMs. (3) DRAM The DRAM is a 4MB resident memory on the main control board that stores edited data, image data, DLL data and macro data. (4) EEPROM 4,096-bit Electrically Erasable PROM (EEPROM), is loaded with the following kinds of data: • • • Menu data Various counter data (page counter, drum counter) Adjusting parameters (LED head drive time, print start position, paper feed length) (5) Parallel Interface Parallel data is received from a host system via parallel interface which conforms to the IEEE1284 specification. (6) USB Interface Serial data is received from a host system via USB which conforms to the USB 1.1 specification. 41356901TH Rev.2 18 /