Download CRS-300 Manual - Comtech EF Data

Transcript
CRS-300 1:10 Redundancy Switch
Switch Connectors and Pinouts
3.2.2.2
MN/CRS300.IOM
Revision 19
EIA-232/422/V.35/LVDS Connector, DB-25F (CRS-320/340)
Table 3-5 indicates the pinout for the DB-25F EIA-232/422/V.35/LVDS User Data Interface
connector – “J1” on the CRS-320 TMI (obsolete), and “J2” on the CRS-340 TMI.
Table 3-5. EIA-232/422/V.35/LVDS Connector
Pin
Generic Signal Function
Circuit No.
EIA-232
EIA-422/530
V.35
Modem to DTE
114
---
ST B
SCT B
Transmit Clock ‘A’
11 Transmit Clock ‘B’
External Carrier Off
23
(EIA-232 ‘1' or TTL ‘low’)
10 Receiver Ready ‘B’
22
Note 2
DTE to Modem
DTE to Modem
113
113
DA
---
TT A
TT B
SCTE A
SCTE B
DTE to Modem
---
---
---
---
Modem to DTE
109
---
RR
B
9 Receive Clock ‘B’
Note 2
8 Receiver Ready ‘A’
Modem to DTE
115
---
RT B
SCR B
Modem to DTE
109
CF
RR A
RLSD *
---
102
AB
SG
SG
6 Note 2
Note 2
5 Note 2
Receive Clock ‘A’
Modem to DTE
115
DD
RT A
SCR A
4 Note 2
Receive Data ‘B’
3 Receive Data ‘A’
Modem to DTE
Modem to DTE
104
104
--BB
RD B
RD A
RD B
RD A
Internal Transmit Clock ‘A’
2 Transmit Data ‘A’
Transmit Data ‘B’
Modem to DTE
DTE to Modem
DTE to Modem
114
103
103
DB
BA
---
ST A
SD A
SD B
SCT A
SD A
SD B
13 Note 2
25
Note 2
12 Internal Transmit Clock ‘B’
24
21
20
19
18
17
16
15
14
Note 2
7 Signal Ground
Note 2
Direction
1 Shield
--101
AA
Shield
FG
Notes:
1) “Receiver Ready” is an EIA-232-level control signal on a V.35 interface.
2) Do NOT connect signals to these pins – they are reserved for use by the redundancy system.
3) 'B' signal lines are not used for EIA-232 applications.
4) For X.21 operation, use the EIA-422 pins, but ignore Receive Clock if the modem is DTE, and ignore Transmit clocks if the modem is DCE.
3–8