Download Elegant Entry Divider
Transcript
o
rp
tethniques
CONSTRUCTION
VIEW
-----...-Top
0/n"Hordboord,
24" x24"1
FromeCenter
l3/t"x lVz" x2l"l
stowit for storoge:
OUTFEED
SUPPORT
\
-:-
1gttLocking
,""1*
Assembly
l7z"-wide
robbet,
# 1 0x l % , ,
#6x3/t,
UqPer
fi;.h;;;.'"*,.r.T;:),ii3,
*ffi #"q Fh
r''
t/t" x ll/t" Hex Bolt
.--..--l
#8x3A,'J
,
V+
-b
An outfeed support for a table saw is an indispensable
accessory.Andit doesn't need to be elaborate or expensive to do its job well.Thke this one, for example.'When
you need to cut a long board or wide panel, you simply
Lower
lMetol
Strop
_ Spocer
l/2" x3/4" x2"l 1s4r"x3/t" x'5"1
NOTE:Spocerthickness
moy vory dependingon sow
attach it to the table saw by means of a couple of shopmade hangers (InsetPhoto).When you're done, the support can be removed in secondsand folded for storage.
Top - The top of this outfeed support is a piece of
1/4" hardboard that attaches to a wood frame
(C onstructionVi ew).The frame consistsof severalpieces
of 3,/+"-thick stock rhat are simply cut to length, rhen
screwed to the top.
Legs - The outfeed support is held up by two legs
which are connected by a pair of thick rails.The rails are
rabbeted to fit over the legs and fastened with screws.
AT:nut and bolt installed in the bottom of each leg lets
you adjust the height ofthe support for uneven floors.
The legs are connected to the top with strap hinges.
And a pair of locking support hinges prevent the legs
from collapsing during use.
Hangers - To attach the outfeed support to the
table saw, you'll need to add the two hangers. Each
hanger consistsof two metal strapswith a wood spacer
block sandwiched in between them (HangerDetail).The
upper strap is bent to fit over the back rail ofthe rip
fence. (l bent the strap in a machinist's vise.)The lower
strap,which is straight, is cut to length and screwed ro
the top frame.
As for the spacerblock, size it so the outfeed support
will sit just a hair below the table saw.Then secure it
befween the rwo strapswith machine screws and nurs.
Forsending
us thisfeaturetip,
AlbertDowdwinsa new8T3700
Ryobitahlev,w!
s
t.'
Mailfipsto:
Workbench
Tips&
Techniques
2200Grand
Ave.
DesMoines,
lA50312
Emait eoito@
workbenchmag.com
T4
/t-
AlbertDowd
Concord,
NC
woRKtsENcH
!
FEBI{uAnv
2005