Download Axis Q8722-E
Transcript
AXIS Q87-E Installation Guide Page 13 Attach the AXIS Q87-E Dual PTZ Network Camera Series to the Base 1. Make sure the seal is in position. 2. Remove the sunshield, which is placed on but not attached to, from the top cover. 3. Attach the Pan/Tilt control unit, motor and camera assembly to the base and tighten the screws (torque 4 Nm). Use the alignment indicators to align the units. Incorrect alignment could cause damage to components. 1 3 4 5 6 7 1 2 3 Pan/Tilt control unit, motor and camera assembly Configuration board lid Alignment indicators 4 5 6 7 Seal Base Washer (4x) Screw (4x) 4. Aim the dual PTZ network camera to the point of interest and focus the thermal network camera if required, see Focus Adjustment - AXIS Q1921/AXIS Q1922, on page 18. See Access the Video Stream, on page 18 and the Installation and Management Software CD for information on how to view the video stream. 5. Install the counterweights, see Install the Counterweights, on page 14 or install the selected illuminators (sold separately), see page 16. Infrared LED Illuminators are available as accessories, see www.axis.com for information of available illuminators. Either counterweights or illuminators shall be installed. Any other installation method will void the warranty and could leave the unit at a risk ENGLISH 2
This document in other languages
- français: Axis Q8722-E
- español: Axis Q8722-E
- Deutsch: Axis Q8722-E
- italiano: Axis Q8722-E