Download Supermicro Xeon
Transcript
Table 41. Signal Definitions (Sheet 6 of 9) Name LINT[1:0] LOCK# Mechanical Key MCERR# ODTEN PROCHOT# Type Description Notes I LINT[1:0] (Local APIC Interrupt) must connect the appropriate pins of all front side bus agents. When the APIC functionality is disabled, the LINT0 signal becomes INTR, a maskable interrupt request signal, and LINT1 becomes NMI, a nonmaskable interrupt. INTR and NMI are backward compatible with the signals of those names on the Pentium processor. Both signals are asynchronous. 3 Both of these signals must be software configured via BIOS programming of the APIC register space to be used either as NMI/INTR or LINT[1:0]. Because the APIC is enabled by default after Reset, operation of these pins as LINT[1:0] is the default configuration. I/O LOCK# indicates to the system that a transaction must occur atomically. This signal must connect the appropriate pins of all processor front side bus agents. For a locked sequence of transactions, LOCK# is asserted from the beginning of the first transaction to the end of the last transaction. 4 When the priority agent asserts BPRI# to arbitrate for ownership of the processor front side bus, it will wait until it observes LOCK# deasserted. This enables symmetric agents to retain ownership of the processor front side bus throughout the bus locked operation and ensure the atomicity of lock. Inert Mechanical Key to prevent compatibility with 603-pin socket. I/O MCERR# (Machine Check Error) is asserted to indicate an unrecoverable error without a bus protocol violation. It may be driven by all processor front side bus agents. MCERR# assertion conditions are configurable at a system level. Assertion options are defined by the following options: • Enabled or disabled. • Asserted, if configured, for internal errors along with IERR#. • Asserted, if configured, by the request initiator of a bus transaction after it observes an error. • Asserted by any bus agent when it observes an error in a bus transaction. For more details regarding machine check architecture, refer to the IA-32 Software Developer’s Manual, Volume 3: System Programming Guide. Since multiple agents may drive this signal at the same time, MCERR# is a wire-OR signal which must connect the appropriate pins of all processor front side bus agents. In order to avoid wire-OR glitches associated with simultaneous edge transitions driven by multiple drivers, MCERR# is activated on specific clock edges and sampled on specific clock edges. I ODTEN (On-die termination enable) should be connected to VCC to enable on-die termination for end bus agents. For middle bus agents, pull this signal down via a resistor to ground to disable on-die termination. Whenever ODTEN is high, on-die termination will be active, regardless of other states of the bus. O PROCHOT# (processor hot) indicates that the processor Thermal Control Circuit (TCC) has been activated. Under most conditions, PROCHOT# will go active when the processor’s thermal sensor detects that the processor has reached its maximum safe operating temperature. See Section 6.3 for more details. These signals do not have on-die termination and must be terminated at the end agent. See the appropriate Platform Design Guideline for additional information. Intel® Xeon™ Processor with 533 MHz Front Side Bus at 2 GHz to 3.06 GHz 65