Download Avaya Configuring Data Compression Services User's Manual
Transcript
Data Compression Overview PPP Hi/fn LZS Compression Protocol PPP uses CCP to negotiate how the router uses the Hi/fn LZS Compression Protocol (RFC 1974). Specifically, CCP negotiates the different compression modes that RFC 1974 supports. Bay Networks negotiates only mode 3 and the number of compression histories, of which we support only one history. RFC 1974 is specified only as an error detection protocol; unlike WCP, it does not contain a transmit history. Instead, it relies on upper layer protocols to retransmit data when errors occur. For more information about compression protocol modes, refer to RFC 1974. Data Compression Performance The goals in using data compression are to achieve a high compression ratio while maximizing throughput. Compression ratio is the size of uncompressed data compared to the size of the same data after it is compressed. Throughput refers to the amount of data that goes across the network in a specific amount of time. The amount of throughput can indicate the efficiency and speed of the network. The compression ratio varies according to the effectiveness of the compression algorithm, but also according to the characteristics of the data you are transmitting. Data that includes many redundant strings compresses at a high ratio. Throughput varies according to the number of devices in the network through which the data must travel. Throughput is also affected by the compression and decompression process. Hardware Compression Bay Networks hardware-based compression works with frame relay and PPP networks. It best serves sites that support T1 or E1 lines, which often concentrate many lower-speed remote connections. The hardware compression facility operates at high speeds and also supports high-density WAN connections. Use hardware compression when you want to achieve high compression ratios and throughput, and also want to conserve router memory for other functions. 303519-A Rev. 00 2-5