Download Avaya IP Telephony Configuration Guide
Transcript
153 Appendix A Efficient Networking This section provides information about making your network run more efficiently. • • • • • “Determining the bandwidth requirements” on page 153 “Network engineering” on page 154 “Additional feature configuration” on page 159 “Further network analysis” on page 162 “Post-installation network measurements” on page 165 Determining the bandwidth requirements The IP network design process starts with the an IP telephony bandwidth forecast. The bandwidth forecast determines the following: • • LAN requirements: LAN must have enough capacity for the number of calls plus the overhead WAN requirements: WAN must have enough capacity for the number of calls plus the overhead Determining WAN link resources For most installations, IP telephony traffic travels over WAN links within the intranet. WAN links are the highest recurring expenses in the network and they are often the source of capacity problems in the network. WAN links require time to receive financial approval, provision and upgrade, especially inter-LATA (Local Access and Transport Area) and international links. For these reasons, it is important to determine the state of WAN links in the intranet before installing IP telephony. Link utilization This procedure explains how to determine and adjust link utilization: 1 Get a current topology map and link utilization report of the intranet. A visual inspection of the topology can indicate the WAN links anticipated to deliver IP telephony traffic. 2 Record the current utilization of the links that will be handling IP telephony traffic. For example, the link utilization can be an average of a week, a day, or one hour. To be consistent with the considerations, get the peak utilization of the trunk. 3 Determine the available spare capacity. Business Communications Manager intranets are subject to capacity planning controls that ensure that capacity use remains below a determined utilization level. For example, a planning control can state that the utilization of a 56 kbit/s link during the peak hour must not exceed 50%. For a T1 link, the threshold is higher, at 85%. The carrying capacity of the 56 kbit/s link can be 28 kbit/s, and for the T1, 1.3056 Mbit/s. In some IP Telephony Configuration Guide