Download BENDIX BW2261 User's Manual
Transcript
SYSTEM CONFIGURATIONS Available Configurations A wide variety of system configurations are available (refer to Figure 17). It is important to be able to read system configurations and to be able to properly reconfigure a system when necessary. When to Configure Fault Codes ECUs are factory configured for the most common requirements. Basic systems are setup for 4s-4m operation with retarder control via retarder relay. Standard systems are setup for 6s-4m operation with retarder control via engine data link. For applications other than these factory configurations (for example use of a retarder control relay, 4s-3m operation, 6s-6m operation or traction control), it is necessary to perform a configuration or “setup” process. This process sets up the ECU for the components that are installed so that proper control and fault tolerance will be implemented. The diagnostic switch, MPSI Pro-Link® tool or ServiceRanger PC software may be used to configure to a higher level (add components or functionality). If it is desired to move the configuration downward (fewer components than standard), the ProLink tool or ServiceRanger PC software must be used. How to Configure Use the “SYSTEM SETUP” menu with the MPSI ProLink® tool, the diagnostic switch (refer to page 25 for procedure) or ServiceRanger PC software. Use of the “SETUP” function will also clear inactive trouble codes from the system. However it is recommended that the “CLEAR TROUBLE CODES” function be used for clearing inactive codes. Verification It is important to verify that the intended configuration has been obtained. Refer to Figure 20 (page 17) for proper interpretation of configuration blink codes. Tone Ring Wheel Speed Sensor (WSS) Pressure Modulator Valve (PMV) 4S - 4M Rear Axle Valve Assembly ATC Valve 6S - 6M w/ATC 6S - 4M w/ATC FIGURE 18 - Typical ABS Configurations 15