Download Operating instructions Zero 3 5-channel stepper motor - CNC-Step

Transcript
Operating instructions Zero3
5-channel stepper motor controller
4 Commissioning
4.1 Installation
The controller should be installed in such a way that the controls on the front panel,
especially the E-Stop switch, are freely accessible at all times. There should be free air
flow to the ventilation openings on the housing.
Appropriate measures (housing, protective walls, suction ...) should be adopted to
ensure that the controller remains free of shavings, dust and liquids (oil, cooling water).
Metal swarf and cooling water can cause short circuits. Dust can interfere with ventilation
and thus cause overheating. Both of these can lead to irreparable damage and risk of
fire.
4.2 Power supply line
The controller is equipped with a universal AC adapter and can be operated without
adjustment using line voltages from 115 to 240VAC. If you are operating the equipment
in a foreign country make sure that you use only appropriate and authorized power cord
and power outlet adapters. These must have a PE conductor and be designed for a load
of up to 16A.
4.3 Connecting the machine
Connections for the positioning motors (connectors X1, X2, Y and Z), the rotating axis or
tangential unit (connector C), if present, and the end position switches and E-stop
switches (connector ST) are located on the front panel. Before connecting the connector
make sure that the assignment of individual contacts corresponds to the schematic
shown below.




Incompatible connections lead to the risk of damaging parts of the
controller or destroying it.
In addition, the proper functioning of the system can be reduced
through this and safety functions which serve to protect life and limb
can be disabled.
Insert or remove connectors only with the controller switched off!
Always lock connectors using the screws located on the connector
housing. The electronic equipment is protected against short-circuits
and interruption of the motor cable. However, unreliable contacts can
lead to incorrect positioning and/or arcing, which can result in
breakage of tools, destruction of the workpiece or reduction of the
service life of the system.
Siemensstrasse 13-15
47608 Geldern, Germany Phone +49 (0)2831/91021-20
Page 11
12.10.2012