Download Operating Instructions Global Drive Fieldbus function

Transcript
Show/Hide Bookmarks
Safety information
2.2
Residual hazards
Protection of persons
l Before working on the controller, check that no voltage is applied to the power terminals and the relay output,
– because the power terminals U, V, W and BR0, BR1, BR2 remain live for at least 1 second after mains
switch-off.
– because the power terminals L1, L2, L3; U, V, W und BR0, BR1, BR2 remain live when the motor is stopped.
– because the relay outputs K11, K12, K14 remain live when the controller is separated from the mains.
l For the use of the function “Selection of direction of rotation” (C0007, C0410):
– The drive can reverse the direction of rotation in the event of a control-voltage failure or a cable break.
l If you use the function ”Flying-restart circuit” (C0142 = -2-, -3-) with machines with a low moment of inertia
and a minimum friction:
– The motor can start for a short time or reverse the direction of rotation for a short time after enabling the
controller when the motor is at standstill.
l The heat sink of the controller has an operating temperature of >60 °C:
– Direct skin contact results in burnings.
Controller protection
l Cyclic connection and disconnection of the controller supply voltage with L1, L2, L3 can exceed the input
current limit:
– Allow at least 1 second between disconnection and reconnection.
l Depending on the controller settings, the connected motor can be overheated:
– For instance, longer DC-braking operations.
– Longer operation of self-ventilated motors at low speed.
Overspeeds
l Drives can reach dangerous overspeeds (e.g. setting of inappropriately high field frequencies):
– The controllers do not offer any protection against these operating conditions. For this, use additional
components.
2.3
Layout of the safety information
All safety information given in these Operating Instructions has the same layout:
Signal word (characterizes the severity of danger)
Note (describes the danger and gives information how to avoid it)
Icons used
Warning of
damage to
persons
Warning of
hazardous
electrical voltage
Warning of a
general danger
Signal words
Danger!
Warns of impending danger.
Consequences if disregarded:
Death or severe injuries.
Warning!
Caution!
2-2
Warning of
damage to
material
Stop!
Other notes
Tip!
BA8200AUT
Warns of potential, very hazardous situations.
Possible consequences if disregarded:
Death or severe injuries.
Warns of potential, hazardous situations.
Possible consequences if disregarded:
Light or minor injuries.
Warns of potential damage to material.
Possible consequences if disregarded:
Damage of the controller/drive system or its environment.
Designates a general, useful note.
If you observe it, handling of the controller/drive system is made
easier.
EN
1.0