Download Hardware and Peripherals User Guide

Transcript
Chapter 3
XChecker Cable and Logic Probe
The XChecker cable and software supports the following Xilinx
FPGAs:
●
XC2000, XC2000L
●
XC3000, XC3100, XC3000A, XC3000L
●
XC3100A
●
XC4000, XC400A, XC4000H
●
XC5200
You can use XChecker to download, read back, verify design
configuration data, and probe internal logic states of your designs.
This chapter describes the XChecker hardware and how to use the
software on workstations and DOS-based PCs. Refer to the Hardware
Debugger User Guide for information about using the XChecker cable
and software on windows for PCs.
The XChecker cable and software support the following capabilities.
●
XChecker allows you to download a design to the FPGA on the
target system.
●
The optional +3-V adapter, which you can order separately, allows
user target systems containing XC2000L and XC3000L lowvoltage FPGA devices to interface with XChecker.
●
XChecker can verify its configuration by comparing it to the
original design after configuring an FPGA.
●
You can probe an FPGA’s internal logic with XChecker to debug
your designs. Probing is the execution of a readback of all the
configuration data and extracting the internal logic states of
desired signals from it.
Hardware & Peripherals User Guide — 0401305 01
3-1