Download USER MANUAL - Walther Flender

Transcript
5. Programming keypad
How to move to other groups at the 1st code of each group.
-. The 1
st
1
code in drive group “0.0” will be displayed when AC input power is
applied.
-. Press the right arrow (X) key once to go to Function group 1.
-. The 1 code in Function group 1 “F 0” will be displayed.
st
2
-. Press the right arrow (X) key once to go to Function group 2.
-. The 1 code in Function group 2 “H 0” will be displayed.
st
3
-. Press the right arrow (X) key once to go to I/O group.
-. The 1 code in I/O group “I 0” will be displayed.
st
4
5
-. Press the right arrow (X) key once again to return to drive group.
-. Return to the 1 code in drive group “0.0”.
st
♣ If the left arrow key (W) is used, the above will be executed in the reverse order.
How to move to other groups from any codes other than the 1st code
Pressing
left
or
right arrow key in
any code will return
to
first
code
of
each group.
Function
group 2
Function
group 1
SERIES N
When you would like to move from the F 15 to function group 2
1
-. In F 15, press the Left (W) or Right arrow (X) key. Pressing the key goes to the
first code of the group.
st
2
3
-. The 1 code in function group 1 “F 0” is displayed.
-. Press the right arrow (X) key.
st
-. The 1 code in function group 2 “H 0” will be displayed.
5-4