Download PDF Manual ATCOR3

Transcript
CHAPTER 2. BASIC CONCEPTS IN THE SOLAR REGION
16
to molecular (Rayleigh) and aerosol scattering, and due to molecular absorption (e.g., water water,
ozone etc.). The total optical thickness is the sum of the thicknesses of all individual contributors :
δ = δ(molecular scattering) + δ(aerosol) + δ(molecular absorption)
(2.3)
R visibility parameter scales the aerosol content in the boundary layer (0 - 2 km
The MODTRAN
altitude). For visibilities greater than 100 km the total optical thickness asymptotically approaches
a value of about 0.17 which (at 550 nm) is the sum of the molecular thickness (δ = 0.0973) plus ozone
thickness (δ = 0.03) plus a very small amount due to trace gases, plus the contribution of residual
aerosols in the higher atmosphere (2 - 100 km) with δ = 0.04. The minimum optical thickness
or maximum visibility is reached if the air does not contain aerosol particles (so called ”Rayleigh
limit”) which corresponds to a visibility of 336 km at sea level and no aerosols in the boundary
layer and higher atmosphere. In this case the total optical thickness (molecular and ozone) is
about δ = 0.13. Since the optical thickness due to molecular scattering (nitrogen and oxygen) only
depends on pressure level it can be calculated accurately for a known ground elevation. The ozone
contribution to the optical thickness usually is small at 550 nm and a climatologic/geographic
average (331 DU) can be taken. Nevertheless, if scene information on ozone is available, it can
be specified as an input parameter. This leaves the aerosol contribution as the most important
component which varies strongly in space and time. Therefore, the aerosol optical thickness (AOT)
at 550 nm is often used to characterize the atmosphere instead of the visibility.
Figure 2.1: Visibility, AOT, and total optical thickness, atmospheric transmittance.
The atmospheric (direct or beam) transmittance for a vertical path through the atmosphere can
be calculated as :
τ = e−δ
(2.4)
Fig. 2.1 (right) shows an example of the atmospheric transmittance from 0.4 to 2.5 µm. The
spectral regions with relatively high transmittance are called ”atmospheric window” regions. In
absorbing regions the name of the molecule responsible for the attenuation of radiation is included.
Apparent reflectance