Download GSK96 Multi-function Position Control System User Manual(2013-3-2)

Transcript
Preface
IV. Notes and Safety Suggestions for Operating Machine
1) Before parts processing
Test the machine without workpiece or tools. Make sure that the machine runs well before it
starts to work.
2) Before operating the machine
Check the input data of the system carefully before operating the machine. Incorrect input
data may cause the machine to work improperly, and damage the workpiece and the tool,
as well as injure the operator.
3) Adaptations between appointed federate and machine operations
Make sure that the input feedrate of the system is suitable for the expected operation.
Feedrate has a maximum for each machine, and the amount of the feed rate is subject to
change with operation. Choose the maximum according to the instructions of the machine.
Improper feedrate leads the machine to work wrongly, and damage the workpiece and the
tool, as well as injure the operator.
4) Compensation function
When offset is needed, check the direction and the amount of the compensation.
Improper compensation causes the machine to work wrongly, and damage the workpiece
and the tool, as well as injure the operator.
5) Manual operation
If the machine is to run in JOG working mode, check the current position of the tool and the
workpiece, and correctly specify the moving axis, moving direction and the feedrate. MPG
(Hand wheel) control with great override, such as 100%, rotate MPG (used to call electric
hand wheel), then the tools and workbench will move fast, which may lead the stop of the
MPG. However, the tools and workbench will not stop immediately. The high override of
MPG movement may damage the machine and its tool, even injure the operator.
6) MPG returns to the reference point
If the tool is return to the reference point, make sure that the machine has been equipped
with the device to detect the reference point; otherwise, the tool cannot reach the reference
point, which may damage the machine and its tool, and even injure the operator.
IX