Download Industrial - X Horizontal - Instructions

Transcript
Assembly/Installation
Gear unit with hollow shaft keyed connection
5
5.9
Gear unit with hollow shaft keyed connection
5.9.1
General information
The material of the machine shaft as well as the keyed connection should be dimensioned by the customer according to the loads that will occur. The shaft material should
have a yield point of at least 320 N/mm² (46,400 lb/in²).
The key length should be, at minimum, that shown in the dimension sheets (Æ section
5.9.3). If a longer key is used, it should be aligned symmetrically to the hollow shaft.
With a through-going machine shaft or axial forces, SEW-EURODRIVE recommends
that the machine shaft be designed with a contact shoulder. In order to prevent the
retaining screw of the machine shaft from loosening upon a reversing load direction, it
should be secured with a suitable threadlocker. If necessary, two eccentric retaining
screws may be used.
5.9.2
Thread sizes/tightening torques
SEW-EURODRIVE recommends the following thread sizes and tightening torques:
Recommended thread size
[8]1)
•
•
•
Threaded rod [2]1)
Nut (DIN934) [5]1)
Retaining screw [6]1)
Strength class 8.8
Tightening torque [Nm (in·lb)]
Retaining screw [6]1)
Strength class 8.8
Gear unit size
Ejector screw
(threads in the end plate)
XA180-230
M36
M30
1,450 (12,830)
XA240-250
M42
M36
2,500 (22,130)
1) See the following pages
Tightening torque
Gear unit size
Thread size for
6 x retaining screws [3]1)
Strength class 10.9
Assembly / Operating status
[Nm (in·lb)]
Disassembly [Nm (in·lb)]
XA180-190
M10x30
48 (420)
Apply hand pressure
XA200-230
M12x30
86 (760)
Apply hand pressure
XA240-250
M16x40
210 (1860)
Apply hand pressure
1) See the following pages
52
Operating Instructions – Industrial Gear Units X.. Series