Download User Manual

Transcript
GSK983M Milling CNC System User Manual (Volume I: Specifications and Programming)
G97
Constant surface speed control OFF
r/min
To exert constant surface speed control, it is necessary to establish a workpiece coordinate
system so that the coordinates of center of the rotation axis are 0 (the axis that exerts constant
surface speed control).
The axis for constant surface speed control may be selected through programming command.
1
2
3
4
G96P
——;
P1……………………Constant surface speed control is designated to axis X.
P2……………………Constant surface speed control is designated to axis Y.
P3……………………Constant surface speed control is designated to axis Z.
P4……………………Constant surface speed control is designated to the 4th axis.
P5……………………Constant surface speed control is designated to 5th axis.
For P0 or that no axis is specified, the present concerned axis is predetermined by No. 315
parameter.
Note 1: To set an axis for constant surface speed control by programming, make sure to specify
Pα (α=1, 2, 3, 4 or5). Otherwise the axis set by parameter setting will be under control.
Whenever G96 is set again, Pα must be always specified. This is independent of whether G96
Pα is specified before that.
Note 2: The surface speed (S) in G96 is considered as S=0 until M03 or M04 is specified. That is
to say, S function cannot be performed before specifying M03 or M04 [only when parameter
TCW (the 7th digit of No. 010 parameter) is 1].
3.8.2.2 Spindle speed
The specified surface speed or spindle speed may be overridden in 50, 60, 70, 80, 90, 100, 110
or 120% by the signal from the operation control panel of the machine.
3.8.2.3 Restraint of maximum speed of spindle
During constant surface speed control, the value in rpm following G92 specifies the maximum
speed of spindle.
G92
S—:
During constant surface speed control, the system will automatically restrain the speed of
spindle to the maximum value if the speed is higher than the programmed value.
3.8.2.4 Rapid traverse (positioning) (G00)
In the rapid traverse (positioning) blocks specified by G00, it is impossible to exert constant
surface speed control by calculating the surface speed in the position of the tool at all times.
However, the control may be achieved by calculating the surface speed from the starting point to
127