Download Operating Instructions

Transcript
Assembly recommendation
Compliance with our recommendations does not release users of our products from their
personal responsibly in relation to local situations and conditions. However, several general
recommendations should be considered:

In the case of kilns up to 60 kg we recommend that you tip the kiln carefully on its
feet. Grip below the kiln 1 and carefully tip it to the side. Assemble the first castor
and then carefully release your grip on the kiln. Repeat this process for all the castors.
We recommend that a second person prevents the kiln from tipping too much, falling
over or rolling away. 3 / 4
3
1
4
2
Fig. 13: Example: Assembling castors on kilns up to 60 kg
Do NOT tip kilns above 60 kg on their feet. There is a risk of the feet "breaking off" if
you tip the kiln. To assemble the castors, we recommend that you sit the kiln on four
suitable wooden blocks. These blocks should be at least 20 cm high, so that the castors
can be screwed beneath the feet. At least two people are needed to lift the kiln, more
for heavier kilns.
min. 20 cm

Kiln base
from below
Fig. 14: Example: Assembling castors on kilns over 50 kg

Pos: 101 /=== Seitenumbruch === @ 0\mod_1158819844943_0.doc @ 2983 @
28
When the kiln is in position, lock the brakes on the castors.
When the bypass connection has been attached to and aligned on the kiln, you can
then assemble an exhaust gas system if this is required. See "Exhaust Gas System" for
more information about exhaust gas.