Download M441U Installation Manual - Conqueror Design & Engineering Ltd

Transcript
3
M441U Installation Manual
3
Installation
3.1
Installing the M441U
Installing the card - Colne...
The picture blow should be similar to your machine...
On some machines the 10-pin connector on the control card is routed to the outside of the
cabinet as a 20-pin connector and housed in a plastic box. If you remove the plastic box
you will find the required 10-pin connector on the board.
The serial cable supplied should be used to connect the 9-pin D-connector from the
upgrade card to a free serial port on your computer.
Copyright © 2006 Conqueror Design and Engineering Ltd.