Download Hardware Troubleshooting Techniques

Transcript
06 0789732769 CH03
8/31/04
12:54 PM
Page 214
214 Chapter 3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
must set up hexadecimal addressing for the port addresses; however, this is
becoming rare as PnP systems improve. For example, a modern parallel port
must be enabled and set to the proper protocol type to operate advanced
peripherals.
For typical printer operations, the setting can normally be set to Standard
Parallel Port (SPP) mode. However, devices that use the port in a bidirectional manner need to be set to Enhanced Parallel Port (EPP) or Enhanced
Capabilities Port (ECP) mode for proper operation. In both cases, the protocol must be set properly for the port and the device to carry out communications.
If serial or parallel port problems are occurring, the CMOS configuration
window displayed during the startup sequence is the first place to look. Read
the port assignments in the bootup window. If the system has not detected
the presence of the port hardware at this stage, none of the more advanced
levels will find it either. If values for any of the physical ports installed in the
system do not appear in this window, check for improper port configuration.
Because the system has not loaded an operating system at the time the configuration window appears, the operating system cannot be a source of port
problems at this time. If all configuration settings for the ports appear correct, assume that a hardware problem exists.
Basic Parallel Ports
Run a software diagnostic package to narrow the possible problem causes.
This is not normally a problem because port failures generally do not affect
the main components of the system. Software diagnostic packages normally
require you to place a loopback plug in the parallel port connector to run
tests on the port. The loopback plug simulates a printer device by redirecting output signals from the port into port input pins.
You can use a live printer with the port for testing purposes; however, this
action elevates the possibility that the printer might inject a problem into the
troubleshooting process.
If there is a printer switch box between the computer and the printer, remove
the print-sharing equipment, connect the computer directly to the printer,
and try to print directly to the device.
Basic Serial Ports
As with parallel ports, diagnostic packages typically ask you to place a serial
loopback test plug in the serial port connector to run tests on the port. Use
the diagnostic program to determine whether any IRQ or addressing conflicts exist between the serial port and other installed options. The serial