Download User Guide - Formula Ford Zetec

Transcript
Alarms
System 2 has been specially designed to trigger an alarm if any of the following
parameters are exceeded:
■
■
■
■
■
■
Max. Water temperature
Max. Oil temperature
Min. Oil or turbo pressure
Min. Fuel or turbo pressure
Max. User 1 or User 2 values
Min. Battery voltage
After an Alarm has been generated, the thresholds are adjusted (until the dash has been
reset), preventing alarms from retriggering after a spin:
■
■
■
Temperature +5°C
Pressures –5 psi
Voltage –0.5 volts
Alarm prevention
To prevent alarms being set off unnecessarily, they are only triggered when:
■
■
the RPM goes above 40% of the red line (i.e. the engine attains 3600 RPM
for a car with a red line set at 9000 RPM), or
the car has been moving for more than 30 seconds.
Adjusting Alarms
You can adjust the Alarm thresholds when the dash is in Configuration mode; see the
‘Configuring the dash’ section.
User channels
User channels are alarmed for use with temperature or thermocouple sensors. If you are
using voltage readings for steering or throttle position, you should set alarm thresholds
in excess of 5.5 volts to prevent the alarms being triggered.
56
System 2 User Guide