Download Version 16 User's Guide

Transcript
8.7 Helmet
Profiles for the first snake process. The profiles for the first snake process are
shown here. The easiest way to draw the profiles is by drawing curves and use
the curve-to-line command to convert them to polylines. In the real life the profile
might be digitized from a model. Draw all elements for the first snake process in
layer 1. Remember that you will need to offset one of the transmission profiles to
get it in the correct height. Observe that the 1st transmission profile is the same
as the 2nd transmission profile for the 1st snake process except for some deviation by each ear. Make the drawing for the 2nd snake process in layer 2.
User’s Guide •
8–13