Download Operators Manual

Transcript
Features
Softkey Menu Trees
3
E
Actual revision numbers may be different for each of the above.
F
Format NV (non-volatile) Memory should be used with caution. Changes are non-reversible. The
softkeys function only when the rear-panel CALIBRATION switch is set to ENABLE, except for the
softkey SETUP, which is not dependent on the CALIBRATION switch position.
All sets all calibration and setup constants to factory setting. CAL set only calibration constants
to factory settings. SETUP resets instrument setup to factory default settings (see Table 3-3).
G
to S
to P
to H
to K
to I
G1
H
HOST selects the Ethernet port or RS-232 (factory default) port. You cannot operate both Ethernet
and RS-232 simultaneously.
gew015.eps
Figure 3-4. SETUP Softkey Menu Displays (cont.)
3-13