Download Installation Manual DIMENSIONS

Transcript
DIMENSIONS
Installation Manual
Dilution trap 50-402
Materials
Upper part: Acid resistant Polyethylene
Catchpot: Heat-resistant borosilicate glass
Capacity: approx. 2,3 litre
Connections: 1 1 /2” BSP x 50mm (quick connection)
Installation
The dilution trap is supplied ready for use. Installation should be
directly near or under the sink. Please check if the upper part and
the catchpot are tightened well to each other, to avoid any
leakage. To tighten, use only the large nut, do not turn the upper
part to tighten. Connect the trap to the sink outlet and the waste
pipe.
Cleaning and Maintenance
The catchpot needs to be emptied and cleaned regularly. When remounting the catchpot to the upper part, make sure that the
silicone ring is fitted in the correct position in the upper part
(position the small holes in the silicone ring on the pins in the
upper part).
Make sure that the couplings are tightened well before use, to
avoid leakage.
Available replacement parts
Upper part (50-403), Catchpot (50-404), Silicone ring (50-405)
For any questions, please call +31-38-4215522.
April 2010
under reserve of changes in design