Download Kinetis Quick Reference User Guide
Transcript
Chapter 1 General System Setup (Software Considerations) 1.1 Overview This chapter provides a quick look at some of the general characteristics of the Kinetis family of MCUs. This is a brief introduction of the operation of the devices and typical software initialization. For more information see the device-specific reference manual and data sheet. 1.2 Code execution The Kinetis family features embedded Flash and SRAM memory for data storage and program execution. Additionally, external memory can be accessed over the FlexBus external bus interface. Code can also be executed over the FlexBus. For maximum performance, executing from internal memory is recommended. 1.3 Reset and booting When the processor exits reset, it fetches the initial stack pointer (SP) from vector table offset 0 and the program counter (PC) from vector table offset 4. The initial vector table must be located in the flash memory at the base address (0x0000_0000). However, the vector table can be relocated to SRAM after the boot-up sequence if desired. Kinetis devices only support booting from internal flash. Any secondary boot must first go through an initialization sequence in flash. After fetching the stack pointer and program counter, the processor branches to the PC address and begins executing instructions. For more information, see the Reset and Boot chapter of the device-specific reference manual. Kinetis Quick Reference User Guide, Rev. 0, 11/2010 Freescale Semiconductor 13