Download User Manual for Multitool

Transcript
Figure X. Multitool asks if you want to create a new CP.
Press “Ok” here and a new CP will be created. The new CP will be attached to a TP with
the time that was specified. Your new Synchronization is finished.
Creating a Synchronized Coding by Drag-Selecting
A synchronized coding has five elements to it; a start CP, an end CP, a start TP, and end
TP and the coding. You can easily create this by left-clicking and dragging a selection in
the TimeScale view, then select Coding->New coding at current position. The Create
new coding dialog will appear. Type something in and press ok.
Figure X. A drag selection in transparent blue has been made in the TimeScale view.
Note that the now line appears at the start of the selection.
You can have the selection traverse already existing synchronizations. Multitool will
figure out and renumber coding point numbers automatically. Interval will also be filled
in automatically in the new coding dialog. The field will be grayed out so you cannot
change it. This is to avoid that the user will make an error.
There are some limitations on the drag selection mechanics that you should be aware of.
• You can only drag select from left to right (The now line will stay at the left side
of the selection).