Download Embedded Peripheral IP User Guide
Transcript
UG-01085 2014.24.07 interruptmask Register 12-7 After reset, all bits of direction are 0, so that all bidirectional I/O ports are configured as inputs. If those PIO ports are connected to device pins, the pins are held in a high-impedance state. In bi-directional mode, to change the direction of the PIO port, reprogram the direction register. interruptmask Register Setting a bit in the interruptmask register to 1 enables interrupts for the corresponding PIO input port. Interrupt behavior depends on the hardware configuration of the PIO core. See the Interrupt Behavior section. The interruptmask register only exists when the hardware is configured to generate IRQs. If the core cannot generate IRQs, reading interruptmask returns an undefined value, and writing to interruptmask has no effect. After reset, all bits of interruptmask are zero, so that interrupts are disabled for all PIO ports. edgecapture Register Bit n in the edgecapture register is set to 1 whenever an edge is detected on input port n. An Avalon-MM master peripheral can read the edgecapture register to determine if an edge has occurred on any of the PIO input ports. If the option Enable bit-clearing for edge capture register is turned off, writing any value to the edgecapture register clears all bits in the register. Otherwise, writing a 1 to a particular bit in the register clears only that bit. The type of edge(s) to detect is fixed in hardware at system generation time. The edgecapture register only exists when the hardware is configured to capture edges. If the core is not configured to capture edges, reading from edgecapture returns an undefined value, and writing to edgecapture has no effect. outset and outclear Register You can use the outset and outclear registers to set and clear individual bits of the output port. For example, to set bit 6 of the output port, write 0x40 to the outset register. Writing 0x08 to the outclear register clears bit 3 of the output port. These registers are only present when the option Enable individual bit set/clear output register is turned on. Interrupt Behavior The PIO core outputs a single IRQ signal that can connect to any master peripheral in the system. The master can read either the data register or the edgecapture register to determine which input port caused the interrupt. When the hardware is configured for level-sensitive interrupts, the IRQ is asserted whenever corresponding bits in the data and interruptmask registers are 1. When the hardware is configured for edge-sensitive interrupts, the IRQ is asserted whenever corresponding bits in the edgecapture and interruptmask registers are 1. The IRQ remains asserted until explicitly acknowledged by disabling the appropriate bit(s) in interruptmask, or by writing to edgecapture. Software Files The PIO core is accompanied by the following software file. This file provide low-level access to the hardware. Application developers should not modify the file. • altera_avalon_pio_regs.h—This file defines the core's register map, providing symbolic constants to access the low-level hardware. The symbols in this file are used by device driver functions. PIO Core Send Feedback Altera Corporation