Download Operating Instructions

Transcript
Installation
Electrical Installation
4
Braking resistor
connection
Installing the
braking resistor
•
Shorten the cables to the required length.
•
Use 2 tightly twisted leads or a 2-core shielded power cable. Cross-section according
to the rated output of the drive.
•
Protect the braking resistor with a bimetallic relay with trip class 10 or 10 A (wiring
diagram).
•
For braking resistors in the BW..-T series, you can connect the integrated thermostat
using a 2-core, shielded cable as an alternative to a bimetallic relay.
•
The flat-design braking resistors have internal thermal overload protection (fuse cannot be replaced). Install the flat-design braking resistors together with the appropriate
touch guard.
•
WARNING Risk of electrical shock. The supply cables to the braking resistors
carry a high voltage (approx. DC 900 V) during rated operation.
Severe or fatal injuries.
– Disconnect and isolate the MOVITRAC® LTP-B from the electrical supply at least
10 minutes before removing the supply cable.
•
CAUTION Risk of burns. The surfaces of the braking resistors become very hot
when they are loaded with Prated.
Minor injuries.
– Choose a suitable installation location.
– Do not touch the braking resistors.
– Install an appropriate touch guard.
22
Operating Instructions – MOVITRAC® LTP-B