Download 2. Installation and Setup

Transcript
2. Installation and Setup
PV Connection (3)
Wiring from the PV panels is connected to the
inverter via Multi-Contact connectors.
2
Illustration 2.9: PV Connection
Individual Configuration
Individual configuration is used when PV panels have different angles, orientation, or are of
varying types.
This is the default setting.
Illustration 2.10: Individual Configuration
Parallel Configuration
Parallel configuration is used when all PV panels are identical both in type and in system installation.
Master/Slave set for parallel configuration.
Illustration 2.11: Parallel Configuration
The inverter runs an automatic PV configuration test just after connection to grid. During this test
the configuration of the PV modules is determined. The inverter will always run according to the
configuration of the PV modules.
For the inverter equipped with a display unit, the status of the test and the result can be found in
menu B in the display.
2.1.5. AC Connection
The inverter must be connected
to the earth wire in order to prevent injury to the user.
Make sure the AC grid is switched off at the mains breaker before connecting the mains cable.
Ensure that the power supply is disengaged using the power disconnect switch before connecting
the power cable.
L00410363-05_2q
11