Download ETKF
Transcript
11. Changing the display view The upper part of the display can be used to show other values instead of the indoor humidity and the indoor temperature. The Display button is used to change the view. The following alternatives are available, depending on whether or not an outdoor temperature sensor has been taught-in to the wall thermostat: No outdoor sensor Indoor humidity and temperature Time and date With outdoor sensor Indoor humidity and temperature Outdoor and indoor temperature Min. and max. outdoor temperature Time and date You can delete the saved min./max. outdoor temperature values by pressing and holding down the Display button for longer than 3 seconds. 12. Teaching-in to radio energy-saving controllers In order to enable communication between radio components, the devices have to be taught-in to one another. Proceed as follows to allow radio energy-saving controllers to be managed via a wall thermostat: • First of all, the radio energy-saving controller must be set to teach-in mode. For more information on this, refer to the operating manual for the relevant device. • The wall thermostat then needs to transmit a radio signal for teaching-in purposes. To do this, press and hold down the OK button on the wall thermostat for longer than 3 seconds. • “LEA” and the remaining teach-in time (starting at 30 seconds) appear on the display and the wall thermostat 28