Download Pro-Head-Spot
Transcript
rpan - Pan Reverse With this function you can reverse the Pan-movement. • Select “rPAN” by pressing [UP] or [DN]. • Press [MODE/ENTER], the display shows“ON” or “OFF”. • Press [UP] to select “ON” if you wish to enable this function or [DN] to select “OFF” if you don’t. • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. rtil - Tilt Reverse With this function you can reverse the Tilt-movement. • Select “rTIL” by pressing [UP] or [DN]. • Press [MODE/ENTER], the display shows“ON” or “OFF”. • Press [UP] to select “ON” if you wish to enable this function or [DN] to select “OFF” if you don’t. • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. - Switch 16 bit/8 bit With this function you can switch the device from 16 bit to 8 bit resolution. • Select “16BI” by pressing [UP] or [DN]. • Press [MODE/ENTER], the display shows“ON” or “OFF”. • Press [UP] or [DN] to select “ON” in order to set 16 bit, or “OFF” in order to set 8 bit. The channels PAN Fine and TILT Fine will be disabled. • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. - Select PAN-degree With this function you can delay the lamp ignition. • Select "DEGR" by pressing [UP] or [DN]. • Press [MODE/ENTER] to confirm; the display shows “ 630”. • Press [[UP] or [DN] to select the desired delgree between "630" and "540". • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. Rest - Reset With this function you can Reset the device via the Control Board. • Select “rEST” by pressing [UP] or [DN]. • Press [MODE/ENTER], the display shows“ON” or “OFF”. • Press [UP] to select “ON” if you wish to enable this function or [DN] to select “OFF” if you don’t. • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. - Restore factory settings With this function you can restore the factory settings of the device. All settings will be set back to the default values (shaded). Any edited scenes will be lost. • Select “LODA” by pressing [UP] or [DN]. • Press [MODE/ENTER], the display shows“ON” or “OFF”. • Press [UP] to select “ON” if you wish to enable this function or [DN] to select “OFF” if you don’t. • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. Ver - Software version With this function you can display the software version of the device. • Select “VER” by pressing [UP] or [DN]. • Press [MODE/ENTER], the display shows “V-X.X”, “X.X“ stands for the version number, e.g. “V-1.0”, “V-2.6”. • Press [MODE/ENTER] to confirm. • Press [EXIT] in order to return to the main menu. 51/113 51838326_V_1_2.DOC