Download Anleitung - Billiger.de

Transcript
HELICON W200
HELICON C200. In surround setups, this makes it possible to position the subwoofer and center
speaker midway between the two main front loudspeakers.
If the subwoofer is used without the center loudspeaker, it can be positioned up against the
wall, because it is a sealed enclosure design without rear-firing bass ports.
HELICON W200 is a medium sized wall-mount loudspeaker which has a variety of options for use. It can be used alone in a compact stereo setup or combined with a subwoofer if more deep bass is
desired. It can also be used as front and/or side/rear speakers in a surround system in combination with a subwoofer.
HELICON W200 comes with an integrated bracket for easy wall mounting.
A piece of rubber foam is supplied with the subwoofer to be inserted between the subwoofer
and the HELICON C200 center channel.
When used as a stereo/front loudspeaker, the dome tweeter should be elevated to approximately
ear height at the preferred listening position.
When used as a rear loudspeaker, the bottom of the cabinet should be approximately at ear
height (the bracket should be mounted approximately 130cm/50” above the floor).
DALI HELICON C200 is designed specifically for use with the other HELICON loudspeakers in a
surround system.
A minimum distance from the rear of the center loudspeaker to the rear wall of at least 10cm/4” is
recommended due to the rear-firing bass reflex ports.
The center loudspeaker is designed to be positioned in the center position relative to the TV set or
projection screen.
For stereo or surround use, the hybrid tweeter module should be below the woofer and the speakers should point towards the listening position.
At the rear of the loudspeaker, there is a vertical groove for the loudspeaker cable.
Mounting
The wall brackets MUST be fitted with rawlplugs suitable for the wall material. The brackets must
be mounted absolutely horizontally.
ENGLISH
ENGLISH
HELICON C200
The bracket must be screwed firmly in place. We recommend using
a spirit level to ensure that the bracket is mounted absolutely level.
The height of the center loudspeaker is less critical than the other HELICON speakers, because the
vertical tilt of the subwoofer can be adjusted due to the curvature of the cabinet. It is preferred
that the drivers are pointing in the direction of the listeners ears. So, if the center speaker is positioned low, it should be tilted backwards.
If the HELICON S600/600MK2 subwoofer is not used as a stand for the center speaker, a dedicated base matching the curvature of the cabinet is sold separately, making it easy to position the
center loudspeaker on a shelf or in a rack system.
The enclosed bushing is mounted on the pin in the middle of the
bracket.
The drivers in HELICON C200 are magnetically shielded. Therefore, the center loudspeaker can be
positioned relatively close to a CRT TV set without disturbing the picture.
14
15