Download DDS Function Generator & Arbitrary Waveform
Transcript
* Do not operate the equipment near strong magnetic fields (motors, transformers etc.) * Keep hot soldering irons or guns away from the equipment. * Allow the equipment to stabilize at room temperature before taking up measurement (important for exact measurements). * Do not input values over the maximum range of each measurement to avoid damages of the meter. * Use caution when working with voltages above 35V DC or 25V AC. These Voltages pose shock hazard. * Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or solvents. * The meter is suitable for indoor use only * Do not operate the meter before the cabinet has been closed and screwed safely as terminal can carry voltage. * Do not store the meter in a place of explosive, inflammable substances. * Do not modify the equipment in any way * Do not place the equipment face-down on any table or work bench to prevent damaging the controls at the front. * Opening the equipment and service – and repair work must only be performed by qualified service personnel * -Measuring instruments don’t belong to children hands- Introduction of PeakTech ® 4035 function generator and PeakTech ® 4050 function / arbitrary waveform generator With Direct Digital Synthesis technique (DDS) and System On Programmable Chip technique (SOPC), ® PeakTech 4035 and 4050 are of the excellent technical performance and powerful function characteristics which are necessary for the fast measurement. TFT-LCD interface can show the illustration of output waveform and parameters. Keypads and knob are convenient for operation. The introduction of characteristics is following: -5 * High frequency accuracy: up to 10 . * High frequency resolution: 9 digits or 1 µHz * Unlimited measurement range: digital setting directly for the whole range. * Non-intergraded process: up to the stable value immediately when switching, continuous signal phase and amplitude without deflection. * High waveform accuracy: the output waveform consists of the computation value of functions with higher waveform accuracy and less distortion. * Multi-waveform: 4 waveforms in common use, 5 built-in waveforms and 5 user- defined waveforms can be output. * Pulse characteristics: variable edge time and accurate pulse width can be output. * Sweep characteristics: with the function of frequency sweeping and amplitude sweeping. Start point and stop point can be set arbitrarily. * Modulation characteristics: FM, AM, PM, PWM and FSK modulation signal can be output. * Burst characteristics: the signal of burst count can be output. * Storage characteristics: 4 groups of user-defined parameters of generator state can be stored and recalled at any moment. -64-