Download SPA D D - AstralPool
Transcript
UTILIZATION MANUAL OPEN EN • Do not fill the Spa through the filtering cartridge. It must be always filled through the base of the Spa. Otherwise, air could get into the pump and damage the circuit. This could damage the Spa. • During the filling process, water should be prevented from entering electrical parts. • If sea water is used in the Spa, the circuit components will quickly deteriorate. • Do not fill the Spa with hot water over 50ºC, as this could trigger off the safety thermostat and damage equipment and connections. CLOSE Turning left we open the valve. The drainage valve has a security thread cap. This provides the needed tightness in case of a bad use of the valve, manipulation by children, etc. 3.3. ELECTRICAL CONNECTION The Spa can be directly connected to the electrical connection of your house if there is a 230 v monophase current. It is essential to have an earthling connection in the base where we connect the plug of the Spa. The maximum consume of the Spa is 2.2 kW. Once the Spa has been filled with water, connect the electrical equipment. (See Electrical connection). Do not use the Spa before carefully reading all the information detailed in the following points: Installing a differential of 30 mA is essential in order to protect from discharges. (Not included. It can be bought in specialised stores). • In the control panel of the Spa, press the jets circuit (see 5.1.1 Control panel of the Spa) in order to correctly start-up the whole circuit. • Adjust water pH between 7.2 and 7.6 (see 7.3. pH adjustment). • Add the required chemical products recommended in “Water maintenance” in the pre-filter basket. Remember that these products cannot be mixed at the same time but they have to be added one by one leaving the necessary space of time. • Select the required temperature (see 5.1. Control panel of the Spa). • If the water is cold, it may take 24 hours to reach a temperature of 38ºC. • Before using the Spa, check the pH values again in case they have changed due to the treatments indicated above. 4. START-UP Before starting-up, read carefully the following points. 4.1. FILLING THE SPA The Spa does not have a specific filling system. Using a manual filling system with a garden hose or similar is recommended. Proceed as follows: • Before filling the Spa, locate the drain valve and ensure that it is CLOSED. • Fill the Spa through the top with clean water up to a minimum level of 3 cm over the highest Jet. 4