Download Contents - MSA World

Transcript
FOR SERVICE TECHNICIAN’S USE ONLY
TEST PROCEDURES
IMPORTANT: The following procedures may
require the use of needle probes to measure
voltage. Failure to use needle probes will
damage the connectors. To ease the process
of measuring voltage and resistance, test points
for each pin are accessible through the slots
in the plastic beneath each CCU connector.
TEST #1: CCU Power Check
This test checks for incoming and outgoing power
to and from Central Control Unit (CCU). This test
assumes that proper voltage is present at the outlet.
1. Unplug washer or disconnect power.
2. Remove top panel to access the
machine electronics.
3. Visually check that all connections to the
interference filter (IF) are securely connected.
See Figure 10, below.
4. Visually check that all connections to the
CCU (Figure 11) and Expansion Board (EB)
(Figure 15, page 21) are fully inserted.
5. If both visual checks pass, go to step 6.
Filter Output - Line (PK)
Filter Input - Power Cord Line (BK)
6. Plug in washer or reconnect power.
7. With a voltmeter set to AC, check for line
voltage at the input of the interference filter.
See Figure 10.

If line voltage is present, go to step 8.

If line voltage is not present, unplug
washer or disconnect power and verify the
continuity of the power cord. If it fails the
continuity check, replace the power cord.
8. With a voltmeter set to AC, check for line
voltage at the output of the interference filter.

If line voltage is present, go to step 9.

If line voltage is not present, unplug washer
or disconnect power and replace the
interference filter.
9. With a voltmeter set to AC, check for input
line voltage to the CCU across pins 1 and 2 of
connector IF2. See Figure 11.

If line voltage is present, go to step 10.

If line voltage is not present, unplug washer
or disconnect power. Check harnesses and
connections between the filter and the CCU.
Repair as necessary.
Filter Output - Neutral (PK)
Filter Input - Power Cord Neutral (WT)
Figure 10 - Interference Filter (IF)
DL3-Door Lock Coil
DI6-Detergent Dispenser Motor
FM3-Flow Meter
DCS3-Door Closed Switch
DP2-Drain Pump
RP2-Vent Fan
VCH7-Hot/Cold Valves
VSF2-Steam Valve
Locking Tab
MS2-MCU Power
PS8-Pressure Sensor
SET2-Temperature
Sensor
UIP3-Expansion
Brd Power
UI7-User Interface
MI3-MCU
Communications
FAC3-Data
to Expansion Brd
IF2-Interference
Filter
DLS2-Door
Lock Switch
HE2-Heater
Element
HSG2-Expansion
Board
• = pin-1
Figure 11 - Central Control Unit (CCU)
DO NOT REMOVE OR DESTROY
PAGE 13