Download 2 - Danby
Transcript
Important Safety Information READ AND FOLLOW ALL SAFETY INSTRUCTIONS FOR YOUR SAFETY: Read these instructions carefully before operating the unit. ENERGY SAVING TIPS Your Danby appliance is designed to be highly efficient in energy savings. Follow these recommendations for greater efficiency. 1) Select a thermostat setting that suits your comfort needs and leave at that chosen setting. 2) The air filter is very efficient in removing airborne particles. Keep the air filter clean at all times. (usually cleaned every 2 weeks depending on indoor air quality). 3) Use drapes, curtains or shades to keep direct sunlight from penetrating and heating the room, but do not allow drapes or curtains to obstruct the air flow around the unit. 4) Start your air conditioner before the outdoor air becomes hot and uncomfortable, to avoid an initial period of discomfort while the unit is cooling off the room. 5) When outdoor temperatures are cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting. Installation Instructions ELECTRIC SHOCK HAZARD To avoid the possibility of personal injury, disconnect power to the unit before installing or servicing. NOTE: Your air conditioner is designed for installation in a standard double hung window with an opening width of 22 8/16” - 38 2/16” (FIG. 1) Fig. 1 Lower sash must open sufficiently to allow a clear vertical opening of 131/2 inches (343 mm). Side louvers and the rear of the AC must have clear air space to allow enough airflow through the condenser, for heat removal. The rear of the unit must be outdoors, not inside a building or garage. NOTE: SAVE CARTON and these INSTALLATION INSTRUCTIONS for future reference. The carton is the best way to store unit during winter, or when not in use. Some assembly is required. Please read these instructions carefully. MOUNTING HARDWARE OFFSET EXTERIOR WALL 22 8/16” - 38 2/16” STOOL SILL QUANTITY 13 1/2” (343mm) INTERIOR WALL *Also please see www.danby.com for video instructions. 2/5"screws 4 4/5"screws 6 Sash Lock 1 TOOLS NEEDED: • Phillips Screw Driver • Drill (If pilot holes are needed) 4