Download GB - Jacobsen
Transcript
GB Fig.23 Fig.24 IMPORTANT NOTE DO NOT TOW THE MACHINE. PUSHING THE MACHINE WITH THE ENGINE STOPPED: FREE WHEEL CONTROL The free wheel control (Fig.23) is provided to allow the machine to be moved when the engine is stationary. The control is situated in the engine compartment on the left hand side. To gain access lift the engine cover , reach between the engine and chassis, about 150mm (6in) below the top of the chassis you will locate the transport valve, to the rear of the valve there are two knurled knobs which operate the free wheel, and can be operated as follows: a. Free wheel: Release the locking knob (A Fig.23) and rotate the handwheel (B Fig.23) fully anticlockwise. b. Drive position: After moving the machine the outer knurled knob (B Fig.23) should be turned fully clockwise and secured with the locking knob (A Fig.23). BRAKE RELEASE The brake release valve (B Fig.24) is situated under the operators platform and is accessible through the right door. 1. Turn the steering wheel so that the rear wheels are in the straight ahead position. 2. Move the brake operating lever to the "Brakes off" position. 3. Open the right hand door in the operators platform and move the valve lever to its uppermost position. 4. Turn the steering wheel to the left, until the steering feels heavy. Do not use excessive force at the steering wheel. CAUTION (a) Brakes should now be OFF (b) Machine can move if on a slope. (c) brakes can still be applied by using the normal brake lever and moving it to the "Brakes on" position. 5. 6. Repeat steps 2 to 4 as necessary. Move the valve lever under the operators platform to its lowest position before starting the engine. NOTE: There is a microswitch fitted to prevent starting the engine unless the valve lever under the operators platform is in the correct running position. CAUTION: Do not bypass the microswitch to start the engine with the valve open, as this will over pressure the brake seals when using the power steering. DO NOT exceed the following speeds and distance when moving the machine in 'Free Wheel'. Maximum Speed: 1.5 Km/Hr (1 mph) Maximum Distance: 2Km (1 1/4 miles) DO NOT allow the machine to free wheel down slopes even when unloading down ramps. GB-NL-F-34