Download Operator Handbook

Transcript
www.WorkshopManuals.co.uk
OPERATION
56
www.maskinisten.net
56
PREPARING THE MACHINE FOR TRAVEL
Tucked-in Travel Position
When travelling on the road or on site there are usually
local rules and safety regulations for the machine travelling
position. The "Road Travelling Position' and 'Site
Travelling Position' described on the following pages are
recommendations that should help you to meet the
requirements of these regulations; they are not necessarily
the applied law:
1
2
3
PLEASE MAKE SURE THAT BEFORE TRAVELLING ON
THE ROAD OR ON SITE, YOU AND YOUR MACHINE
COMPLY WITH ALL THE RELEVANT LOCAL LAWS - IT
IS YOUR RESPONSIBILITY.
4
Whether driving on the road or on site, there are two
possible travelling positions:
1
The 'tucked in' position, i.e., the backhoe is placed
across the back of the machine, as shown at A.
2
The 'central protruding' position, i.e., the backhoe is
placed central and protruding from the back of the
machine, as shown at B.
5
6
7
The attachments must not cause the maximum
overall machine width to exceed 2.5m (8.2ft). If any
part protrudes beyond the outer edge of the rear
frame, it must be marked with red and white stripes
to warn that a hazard exists.
The boom lock must be securely fitted.
In certain territories, it will be necessary to fit a
bucket crowd ram safety strut.
The attachments must not protrude from the back of
the machine by more than 1m (3.28ft). If the
attachments do protrude by more than 1m (3.28ft)
then a rear protrusion plate/light must be fitted. If the
attachment is removed the tipping link must be
secured.
Machine stability must be maintained.
The rear stop/tail indicator lights (both sides) must be
clearly visible from the rear of the machine.
The hydraulic clamps (hydra-clamps) must be
engaged.
Central Protruding Travel Position
Choosing the correct travelling position will depend on the
type of equipment you have fitted to the backhoe.
1
Backhoe Attachments
2
3
4
We recommend that all backhoe attachments be removed
before travelling on the road. However, if the machine IS
driven on the road with attachments fitted, then the
conditions listed under the headings Tucked-in Travel
Position and Central Protruding Position should be
maintained.
5
The attachments must not affect machine stability.
For instance, there must be at least 20% of the total
machine weight acting on the front axle.
The backhoe must be set centrally on the rear frame
and hydraulic clamping engaged.
The boom lock must be securely fitted.
In certain territories, it will be necessary to fit a
bucket crowd ram safety strut.
A protrusion plate/light must be fitted. If the
attachment is removed the tipping link must be
secured and the rear protrusion plate/light must still
be fitted.
B
A
182290
182280
8800 - 1
Purchased from www.WorkshopManuals.co.uk