Download Info Printouts & Parameters

Transcript
119
09/09 Rev. 5.03-01
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – PM 3000
If the flash memory contains more than one data block:
« Press the cut button several times, until the wanted data block appears.
Deleting a data block:
« Press the online button.
Data blocks del.
Delete? --> no
« Press the feed button to change to „yes“.
« Press the online button to delete the block.
All
All data blocks contained in the flash memory are deleted.
EasyPl. file log
Easy-Plug file log
64-xx
ALX 92x
DPM
PEM
PM 3000
¯ Only visible, if a CF-card is inserted.
¯ Activating this parameter may slow down the label rate. Therefore disable
the function after error analysis.
¯ Activating this parameter may cause error messages, which may be
difficult to understand. Therefore disable the function after error analysis. If
an error occurs, disable the function and restart the printer.
Disabled
The file log function is switched off.
All data
All received data, including immediate commands, are written into the log file.
Interpreter data
All data is written into the log file, which the Easy-Plug interpreter reads out
of the reception spooler. Immediate commands are not included.
Log files delete
64-xx
ALX 92x
DPM
PEM
PM 3000
¯ Only visible, if a CF-card is inserted.
No
(Default setting) No function.
Yes
Deletes all log files on the inserted CF card, which fulfil the following conditions:
y Filename matches the scheme „EPxxxxxx.log“
xxxxx = number from 1 to 999999, preceding digits filled with „0“. Example:
„EP000001.log“.
y Location: folder \LOGFILES on CF card
Those conditions are matched by logfiles, which are automatically generated
by SPECIAL FUNCTION > EasyPl. file log.