Download Anvil Controller Service Manual Optimized_0

Transcript
Apply the parking brake, turn off the Key Switch, and turn off the power to the controller by using the
RUN/TOW switch mounted on the plastic composite cover over the controller. Slightly above J11 there
are two LEDs a green and a red one. When the RUN/TOW switch is in the OFF or TOW position the
green LED will be OFF, and will turn ON when the RUN/TOW switch is in the ON or RUN position. Key
switch does NOT kill the power to the controller. With the power OFF, connect KC Host Adapter (five
single wires) into J11, the ten pin connector that is blank on the controller. The connector will only fit
one way, note the locking ramp’s position.
Connect the other end into the USB port in your laptop that has already been powered up and running.
Look for the ICON that says KC Host Tomberlin, and double click and say yes and OK to all the Microsoft
questions, until the following screen appears. Sometimes one has to right click and run as
Administrator:
25