Download Technical Manual // Zakk

Transcript
Removing the driver
Required tools
Step 1
Step 2
- 8 mm allen wrench
- grip (shown) or 24 mm spanner
- vice (not shown) or second grip/24 mm spanner
- spacer for disassemly (Art. No. 000337)
Remove both bolts and install the spacer for disassembly using one of the bolts on the driver side.
Clamp the disc side end cap of the hub using it´s flatened faces with the vice. Tighten the bolt with up to
20 Nm.
The grip must have flat parallel faces. If you do not
have the spacer for disassembly you may use a tube
with 12 mm diameter, 1 mm wall thickness and 10 mm
length. Do not use tubes with diameter greater than
12 mm!
www.last-bikes.com