Download BAS-311H - Brother
Transcript
12. TROUBLESHOOTING Problem Upper thread is breaking. Lower thread is breaking. Needle breaks. Upper thread is not cut. Lower thread is not cut. Cause Remedy Reference Thread is too thick for the needle. Select a thread which is suitable for the needle. CD Instruction manual Needle is not installed correctly. Install the needle so that it faces correctly. CD Instruction manual Thread is not threaded correctly. Thread the thread correctly. CD Instruction manual Damage or burring in parts such as the rotary hook, needle hole plate, needle or thread path. Needle and rotary hook timing is incorrect. Repair the respective part by buffing it. Alternatively, replace the part. Adjust the timing. P.88 Upper thread tension is too strong. Reduce the upper thread tension. CD Instruction manual Thread take-up spring tension is too strong. Reduce the tension of the thread take-up spring. P.87 Thread breaks due to heat. Use a needle cooler unit (optional). Reduce the sewing speed. Damage to the needle hole plate or bobbin case. Repair the respective part by buffing it. Alternatively, replace the part. Lower thread tension is too strong. Reduce the lower thread tension. Needle is bent. Replace the needle. Needle is too thin. Select a needle that is suitable for the sewing conditions. CD Instruction manual CD Instruction manual CD Instruction manual CD Instruction manual Adjust the driver needle guard. P.88 Adjust the needle clearance. P.89 Needle and rotary hook timing is incorrect. Adjust the timing. P.88 Feed timing is too slow. Advance the feed timing. Movable knife is blunt. Replace the movable knife with a new one. P.90 P.92 Fixed knife is blunt. Sharpen the fixed knife or replace it with a new one. P.92 Adjust the timing. P.88 Adjust the standby position of the movable knife. P.90 Movable knife is not picking up the needle thread because the last stitch is being skipped. Refer to “Skipped stitches occur”. P.149 Lower thread tension is too weak. Increase the lower thread tension. CD Instruction manual Needle and rotary hook tip are touching. Movable knife is not picking up the upper thread. (Continued on next page) BAS-311H 150