Download Service Manual

Transcript
Bench Service Procedure
10. On the countershaft front, position the retainer plate with
roll pin in hole at shaft end.
11. Install the front bearing retainer plate and capscrew. If the
capscrew is being reused, apply Eaton Fuller thread sealant
#71205 or equivalent. Torque the capscrew to
90-120 lbs. ft.
Note: Earlier models may have a roll pin in the retainer. This
roll pin is not required and was removed on units
built after 1994.
12. From the rear, remove the countershaft support tool.
13. Install the rear countershaft bearing. Position the bearing
so that the larger chamfer on the bearing inside diameter is
installed towards the shaft. Use a bearing driver that contacts both the bearing inner race and outer race.
14. In the countershaft rear groove, install the rear snap ring.
Note: Make sure the front bearing capscrew is properly
torqued.
Note: Make sure the rear snap ring is in place.
165