Download 310/320 Control Module

Transcript
components
MasterMenu™ Keypad
The MasterMenu™ keypad (pictured below) is located on the front of swing out panel directly below the selection
keypad. The MasterMenu™ keypad is only active when the door is open, so even in the event of vandalism to the
control bezel, no access to the control functions is permitted.The MasterMenu™ keypad consists of seven function
buttons, a * key, four coin payout buttons and the eight keys used to operate the MasterMenu™ functions. The entire
keypad becomes active once the machine door is opened.
Function Buttons
The seven function keys (F1-F7) are assigned to specific pre-determined menu headings, primarily for route service
personnel. See page 4.02 for specific menu heading for each of the function keys.
Pressing the * key before one of the function keys ¡ through ¶ are assigned to the second level of menu headings.
Coin Payout Buttons
The four coin payout buttons are used to pay coins out of an L+ or a standard US (dummy mech).The four coin payout
buttons are
,
,
and
.The four coin payout buttons may also be used to enter pricing
information while assigning prices. For example, to enter a price of $.65, pressing the
key twice, the
key
once and the
key once, would result in .65 appearing on the display. See the price setting section for additional
information.
The s key is used for exiting the current menu without making any changes prior to commitment. Note: Closing the
main cabinet door will have the same effect as if the user pressed the s key and causes the machine to exit the
MasterMenu™ System and return to Operational Mode.
The e key provides a dual purpose operation. It provides the a mechanism for entering a menu. It also provides a
means to commit insertions/modifications/deletions made in a menu item.
The + and - keys are used for incrementing and decrementing the available choices in a menu.
Note: Anywhere in this manual that the + or - keys are defined to sequence through numeric data, the front
panel may be used as an alternate input source.
The < and > keys have a dual purpose operation.They provide a means to select the menu heading immediately to
the left or right of the current menu heading.When inserting data within a menu , these keys also provide a means to
move the cursor from its current position to the position directly to its left or right.
The y key is used to delete the character on the current cursor position, shifting all subsequent characters to the right
of that position left by one.
The f key provides a mechanism to insert a character to the left of the current cursor position, shifting all characters
to the right of that position (including the current character) right by one.
Note: Depressing a function key will not cause you to enter the MasterMenu™ System.
F1
.05
F2
ESC
F3
-
+
.10
F4
INS
F5
F7
.25
F6
*
1.00
DEL
ENTER
2.08