Download Service Mechanics

Transcript
32
05/10 Rev. 5.04-03
SERVICE MANUAL
Service Mechanics
DPM – PEM – ALX 92x
8. Undo the 2 set screws on the buffer disc
[61F]. Remove the buffer disc.
9. Push the foil mandrel through to the opposite side.
D
A
B
C
¯ If necessary, force the foil mandrel out
by tapping it lightly with the plastic hammer.
Assembly
To assemble the device, follow the steps in
the reverse order. Make sure to do the following:
G
E
¯ Mount the buffer disc [61F] with the larger chamfer pointing outwards.
¯ Lightly grease contact surface of the
toothed belt pulley [67E] before assembly.
¯ Mount the brake disc [61D] with the
chamfer pointing outwards.
¯ Screw the cap [61B] and nut [61A] onto
the threaded rod till they reach the depth
noted earlier.
¯ If a new spring [61C] has been mounted, the braking torque must then be set.
P See paragraph Setting braking torque on
page 37.
¯ Following assembly, the belt tension
needs to be set (see below).
[61] Order of parts on the foil winding mandrel
A Nut
B Cap
C Spring
D Brake disc
E Toothed belt pulley
F Buffer disc
G Spacer ring
F