Download troubleshooting - Taylor-Dunn
Transcript
Maintenance, Service, and Repair ADJUST THE PARKING LINKAGE 1. Make sure the key-switch is in the “OFF” position, then remove the key. 2. Place the forward-reverse switch in the center “OFF” position. 3. Set the park brake. 4. Place blocks under the rear wheels to prevent vehicle movement. 5. Disconnect the main positive and negative cables at the batteries. 6. Release the park brake. 7. Disconnect the linkage to the park brake handle by removing the clevis pin at the handle. 8. While pulling on the cross-shaft to take up all of the cable slack, adjust the center linkage so that the cross-shaft tab is vertical. 9. Adjust the side linkage so that the clevis pin can be easily inserted into the handle tab. 10. Install new cotter pins and tighten all jam nuts. 11. Set the park brake. 12. Reconnect the main positive and negative cables at the batteries. 13. Remove blocks from behind the wheels. 14. Release the park brake and test drive the vehicle. NOTE: If there is no adjustment left in the linkages, then the Brake Arm Extension must be rotated to engage the next hole in the arm. Brakes Page 6