Download o - Tokens Only
Transcript
Section 3: Routine Service jp^. 3. Install the hopper In the bill changer and run a few bills through to check for proper hopper operation. CAUTION: A Do not use detergents to clean the hopper. The hopper has been factory lubricated and detergent cleaners destroy this lubrication. TEST PROCEDURES Transport Motor Speed Check The BC-150 transport motor speed and direction are computer controlled. No adjustments can be made, however the encoder on the back of the motor can be checked. The computer detects pulses from this encoder for speed control. 1. Remove the transport from the machine, but keep it plugged in and keep the bill changer power ON. 2. Turn the transport over and connect the Ctommon lead of a voltmeter to P701. Pin 10. Connect the other lead to P701. Pin 9. Turn the transport motor drive shaft very slowly by hand. The meter should alternately read voltages below 0.7 VDC then above 3.8 VDC. 3. One rotation of the motor drive shaft will produce 100 pulses. Dispenser Coin Detector Check 1. Remove the hopper from the machine. 2. Turn the bill changer power on. Verify that the Red LED is lit and is shining on the hole In the upper coin chute assembly (The dispenser hold-down screw may be removed and the dispenser pulled forward to allow viewing). 3. Connect the common lead of a voltmeter to P3 Pin 4 on the CCC. Connect the other lead from the voltmeter to P4 Pin 1. A voltage reading between 2.8 VDC and 5.1 VDC should be observed. 4. Block the light path in the detector with an opaque object. The voltage reading should drop below 0.7 VDC. The CCC should shut-down with the error message: CK L COIN DETCTR. 5. Remove the object blocking the coin detector, then push the FUNCTION button to clear the error. 25238806 3-3